Design for higher ROP in drilling deeper and harder formations, PDC drill bit always drills from ground to bottom directly with less or even a single run, saving large amount of drill time and cost .

Differ from tricone bit, PDC drill bit runs with lower WOB but Higher RPM, so it usually works with downhole motor to pick up rotating speed.

The performance of PDC drill bit depends a lot on PDC cutters, we provide unique solution to specific requirement on varied formations.

An auxiliary fishing tool used to grind an irregular drill pipe, casing, or something that falls on the bottom of a well. A pear-shaped milling shoe or milling cone is used to correct a flattened casing or drill. Rod. Cylindrical grinding shoes can be used to sleeve the formation of the drilled part of the drill string for salvage operations.

The diamond-shoes produced by the diamond milling shoes are finer and require less torque for washing.

Because the scrap is very small, only a low return speed is required to clean the wellbore.
It has a long service life and can reduce the number of trips.

The drag bit has a central core, with at least three, but as many as eight, triangular cutting surfaces. The cutting edges of all or at least half of the total number of the bit’s teeth face the forward end of the bit. Any other cutting edges face the drill string, so that the bit may be used while moving in either direction.

Designed for use in soft formations such as sand, clay or some types of soft rock. And drag bits made with tungsten carbide teeth can improve the performance in hard rock formations.