Natural Diamond Core Bit
Design for higher ROP in drilling deeper and harder formations, PDC drill bit always drills from ground to bottom directly with less or even a single run, saving large amount of drill time and cost .
Differ from tricone bit, PDC drill bit runs with lower WOB but Higher RPM, so it usually works with downhole motor to pick up rotating speed.
The performance of PDC drill bit depends a lot on PDC cutters, we provide unique solution to specific requirement on varied formations.
Drilling in extremely hard formations It is suitable for coring in extremely hard abrasive formations, such as sandstone.
Features
◆Curved crown
The curved crown has a smooth core
◆Radiant waterway design
The bit has radiant waterway design which is suitable for high speed.
Technology
◆The self-sharpening impregnated insert
The self-sharpening impregnated insert keeps the cutting sharp during drilling.
◆The unique matrix formula
The unique matrix formula makes the matrix match the wear and formation,optimizes the cutting
Introduction:
Drilling in medium to hard formations. It is suitable for coring in medium to hard formations with a certain degree of abrasive formation.
Features
1.Drilling in medium to hard formations: It is suitable for coring in medium to hard formations with a certain degree of abrasive formation.
2.High-density tooth arrangement: Medium and high-density tooth arrangement design and high-quality natural diamond can improve drilling speed and prolong the service life of drill bit.
3.The unique matrix formula: The unique matrix formula makes the matrix match the wear and formation, optimizes the cutting edge and wear resistance of diamond which makes the bit obtain a better ROP.
4.Radiant waterway design: The bit has radiant waterway design which is suitable for high speed.aterway design which is suitable for high speed.
Product Specifications:
| IADC code | M712 |
| Number of blades | 18 |
| Total flow area | 0.9 in2 |
| Cutting structure | Natural diamond |
| Standard gauge length | 1-1/2"（38.1 mm） |
| Upper buckle torque | 13.4~16.3KN•m |
| Core barrel size | 6-3/4"×4"(川7-4/5） |
Recommended Operating Parameters:
| Flow rate | 10~30 L/S |
| Rotating speed | 40~80RPM |
| Drilling pressure | 20~80 KN |
