Manufacturing Companies for Pdc Bit 12 1/4″ - Matrix Body PDC Core Bit – DeepFast
Manufacturing Companies for Pdc Bit 12 1/4″ - Matrix Body PDC Core Bit – DeepFast Detail:
Design for higher ROP in drilling deeper and harder formations, PDC drill bit always drills from ground to bottom directly with less or even a single run, saving large amount of drill time and cost .
Differ from tricone bit, PDC drill bit runs with lower WOB but Higher RPM, so it usually works with downhole motor to pick up rotating speed.
The performance of PDC drill bit depends a lot on PDC cutters, we provide unique solution to specific requirement on varied formations.
Introduction:
It is resistant to erosion with long service life which can greatly improve drilling effeciency and save cost.
Features
1.Drilling in medium to hard formations: The drill bit has medium and short parabolic crowns, knife-wing teeth and medium-high density cloth teeth. It can obtain higher rotary speed in formations with low compressive strength and a small amount of abrasiveness.
2.Proprietary Cutting Teeth: 13mm imported special cutting teeth improves the ability to drill hard interlayer.
3.Strengthened Gauge: The use of high strength material improves the wear resistance of gauge and makes it have a longer life with the drill bits.
Product Specifications:
IADC code | M232 |
Number of blades | 12 |
Total flow area | 0.2~1.0 in2(1.3~6.5 cm2) |
Main cutting tooth | 13 |
Standard gauge length | 1″~1.5″(25~38 mm) |
Upper buckle torque | 13.4~16.3KN·m |
Core barrel size | 6-3/4″×4″ |
Recommended Operating Parameters:
Flow rate | 10~30 L/S |
Rotating speed | 40~150 RPM |
Drilling pressure | 30~80KN |
Product detail pictures:
Related Product Guide:
The key to our success is "Good Products Good quality, Reasonable Value and Efficient Service" for Manufacturing Companies for Pdc Bit 12 1/4″ - Matrix Body PDC Core Bit – DeepFast , The product will supply to all over the world, such as: Austria, New Zealand, Belgium, We warmly welcome you to come to visit us personally. We hope to establish a long-term friendship based on equality and mutual benefit. If you want to get in touch with us, please do not hesitate to call. We will be your best choice.
By Mamie from Cologne - 2018.10.31 10:02
The factory technical staff gave us a lot of good advice in the cooperation process, this is very good, we are very grateful.
By Wendy from United Arab emirates - 2017.08.21 14:13